Proxicast LAN-Cell 2 User's Guide download pdf (Page 31)

100

101

Chapter 1 Getting to Know Your LAN-Cell 2

LAN-Cell 2 User’s Guide

1.6 Rear Panel Connections

Figure 5 Rear Panel

The following table describes the LAN-Cell 2’s rear panel connections.

Table 2 Rear Panel Connections

LABEL DESCRIPTION

PWR Connect the included 12V DC power adapter to this power jack.

RESET To erase all user-entered settings, press & hold the reset button with a small object

such as a paperclip for approximately 10 seconds until the PWR LED begins to

flash. This returns the LAN-Cell to its factory default settings (LAN IP = 192.168.1.1

Password = 1234).

LAN/DMZ 1-4 Connect computer equipment to these ports with Ethernet cables. These ports are

auto-negotiating (can connect at 10 or 100 Mbps) and auto-sensing (automatically

adjust to the type of Ethernet cable you use, straight-through or crossover). Set the

ports as LAN or DMZ in the web configurator.

WAN Connect a cable/DSL modem or other 10/100 Ethernet-based WAN equipment to

this port.

AUX Connect an analog modem's RS-232 interface to the AUX port using the Black

dial

backup cable. The AUX port is used only to provide modem dial-backup support for

the wired WAN and Cellular Modem interfaces. The default AUX port

communication parameters are: 115200 bps, no parity, 8 data bits, 1 stop bit,

hardware flow control..

CONSOLE Use the Blue

serial cable to connect a terminal or PC-terminal emulation program to

the LAN-Cell for diagnostic access. The default Console Port communication

parameters are: 9600 bps, no parity, 8 data bits, 1 stop bit, no flow control.

WLAN Attach the supplied cylindrical Wi-Fi antenna to this SMA-RP (reverse polarity)

connector if you will be using the LAN-Cell's integrated 802.11 a/b/g/ access point.

Attaching other types of antennas (such antennas with standard SMA, TNC or

FME connectors) to this jack may damage the antennas and/or WLAN antenna

jack!

3G CARD

SLOT

Insert an activated 3G PC-Card cellular modem into the slot on the right side of the

LAN-Cell. Always power off the LAN-Cell before inserting or removing PC-

Cards, otherwise damage to the LAN Cell or the PC-Card may result.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 649 650

Comments to this Manuals

No comments

Proxicast LAN-Cell 2 User's Guide Page 31

Comments to this Manuals