Proxicast LAN-Cell 2 User's Guide Page 465

  • Download
  • Add to my manuals
  • Print
  • Page
    / 650
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 464
LAN-Cell 2 User’s Guide
465
CHAPTER 31
WAN ISP Setup
This chapter shows you how to configure a remote node to access an ISP via a WAN interface.
31.1 Introduction to WAN ISP Setup
A remote node is required for placing calls to an ISP’s remote gateway. A remote node
represents both the remote gateway and the network behind it across a WAN connection. Note
that when you use menu 4 to set up WAN ISP access, you are actually configuring a remote
node. The following describes how to configure Menu 11.1 - Remote Node Profile, Menu
11.1.2 - Remote Node Network Layer Options and Menu 11.1.4 - Remote Node Filter.
31.2 Remote Node Setup
From the main menu, select menu option 11 to open Menu 11 - WAN ISP Setup (shown
below).
Enter 1 to open Menu 11.1 - Remote Node Profile and configure the setup for your Ethernet
WAN port. Enter 2 to open Menu 11.2 - Remote Node Profile (Cellular 3G WAN) and
configure the setup for your 3G connection. Enter 3 to open Menu 11.3 Remote Node Profile
(Backup ISP) and configure the setup for your Dial Backup port connection (see Chapter 25
on page 427).
Figure 284 Menu 11: WAN ISP Setup
31.3 Remote Node Profile Setup
The following explains how to configure the remote node profile menu.
Menu 11 - WAN ISP Setup
1. WAN (ISP, SUA)
2. CELLULAR(ISP, SUA)
3. -Dial (BACKUP_ISP, SUA)
Enter Node # to Edit:
Page view 464
1 2 ... 460 461 462 463 464 465 466 467 468 469 470 ... 649 650

Comments to this Manuals

No comments